Boat Name
JHANA
Specs
Builder: Yu Ching Marine in Taiwan.
Designer: Doug Peterson
Keel: Fin
Dimensions
LOA: 43 ft 8 in
Beam: 12 ft 9 in
LWL: 38 ft 7 in
Maximum Draft: 6 ft 4 in
Displacement: 30000 lbs Dry Load
Ballast: 10000 lbs
Engines
Total Power: 80 HP
Engine 1:
Engine Brand: Perkins
Engine Model: 4.236
Engine Type: Inboard
Engine/Fuel Type: Diesel
Engine Hours: 500
Propeller: 3 blade propeller
Drive Type: Direct Drive
Engine Power: 80 HP
Cruising Speed: 6 knots
Maximum Speed: 9 knots
Tanks
Fresh Water Tanks: 3 Fiberglass (132 Gallons)
Fuel Tanks: 2 Fiberglass (70 Gallons)
Holding Tanks: 1 Plastic (20 Gallons)
Accommodations
Number of cabins: 2
Number of heads: 2
Electrical Equipment
Electrical Circuit: 12V
Outside Equipment/Extras
Electric windlass
Equipment on JHANA
Jhana Equipment
1. Raymarine st60 Instruments
2. Raymarine E7D Chart-plotter with Radar 2018
3. Raymarine Auto Pilot
4. Raymarine Linear drive Rebuilt 2017
5. Icom IC-M422 VHF with remote
6. Icom IC-M34 Handheld
7. Garmin Handheld GPS map76Cx
8. InReach SE Global Texting and Location
9. One Scuba tank with 50’ Hookah with regulator; mask and fins
10. Gennaker, not used
11. Two West Marine Mustang HIT Self Inflating PFD
12. 4 Life Vests
13. Jack Lines and Tether
14. Misc. Tools
15 LIFESLING 2 Overboard Rescue System New
16. Rocna 88 Pound main Anchor with Approximate 225 feet of chain
17.FX-37 Fortress Aluminum Stern Anchor with Multibraid rode
18 ACR GLOBAL FIX PRO EPIRB
19. ISOTHERM FRIDGE AC/DC
***** OPTIONAL DINGHY*****
PURCHASED 9/28/2018 BUT NOT USED BUT 30 MINUTES, UNDER
COVER ON FLOAT NEXT TO BOAT
HIGHFIELD HYPALON ALUMINUM HULL CL290BL - BOW LOCKER
MODEL PAID $3,752.93 IN 2018 LIST COST TODAY IS $4,125.00
BECAUSE OF COST INCREASES AND TARIFFS
BOW LOCKER WEATHER STRIPED AND STAINLESS HASP AND
THE INSIDE, PAID $800.00 2018
Work Done and Upgrades on JHANA
JHANA - 1979 KELLY PETERSON 44 CUSTOM SAILBOAT
WORK PERFORMED FROM STANDARD BOAT
Previous Owner
1.Rebuilt Perkins 4.236 - about 500 hours now.
2. Replaced fuel and water tanks with fiberglass tanks
3. Raymarine ST 60 instruments; auto pilot
4. Lewmar 54 winches
5. New sails and rigging
Done since I have owner boat ( approximate cost of materials only ,
none of these costs , with a couple exceptions that are noted, include
Labor !!! )
1. Most wiring replaced, Blue Sea Electrical Panel cost about
$1,500.00; 400 amp hour Lithium Ion battery bank 2018 with over /
under solenoid protection cost about $4,000.00
2. New plumbing ( aft head has brand new Raritan High Boy Toilet
$435.00 ); Hot water Heater replaced 2018 with Quick Nautic Stainless
Steel Boiler about $800.00
3. 2018 New Ronco Holding Tank, Sealand Pump , parts about
$800.00 . Custom fiberglass composite board bulkhead designed to
have a water tight top made ( not done) that would make a collision
watertight area under V berth ( cost ? )
4. 2019 New African Mahogany Louvered doors in Forward and Aft
Cabins ; Salon ( Cost of Doors with Stainless Steel Push Latches ,
Stainless Steel Euro Style Hinges , Varnish about $5,000.00 -
$5,500.00 )
5. Cabin Sole - Cocobolo Rosewood with Hard Maple from Forward
Cabin thru Salon to Aft Cabin entrance ( Cocobolo was purchased in
Puerto Vallarta and is not available in this quality in the USA !!! ) . I
bought what was available , under the Salon table, under Nav table
and Aft Cabin is Santos Mahogany with Hard Maple ) cost for wood ,
composite board, fiberglass, glue , floor sealant without labor about
$7,800.00
6. 2019 Santos Mahogany Solid wood Galley Countertops ( wood
about $ 500.00 ) with Krauss Stainless Steel under counter
commercial sink ( $270.00 ) and Geo Axis faucet ( $ 155.00 )
7. 2020 New Foam Backed Vinyl Headliner in both heads and
overhead above both bunks in Forward and Aft Cabins about $570.00
8. Head liner under cabin top in Salon / Galley , Forward and Aft
Cabins - 1 inch Armaflex closed cell foam above ; removable , 1/8
inch Hydrotech Marine Plywood with Bone White Laminate and
African Mahogany Trim cost about $2,000.00 - $2,500.00
9. 2019 Forward and aft cabin Hanging Lockers rebuilt with Alaskan
Yellow Cedar framing , painted beveled Alaskan Yellow Cedar with
1/8” spacing next to hull for venting , New Hydroteck 1/2” Marine
Plywood with Laminate both sides for fronts; Faces of interior
cabinets and bulkheads through out resurfaced with Hydroteck
marine plywood with Laminate or Painted as needed ; Aft Cabin above
berth beveled Alaskan Yellow cedar with 1/8” spacing ; all sliding
doors in both Heads and Aft Cabin replaced with 1/4” Hydrotech
Marine Plywood with Laminate both sides and new Teak door pulls;
New Galley Upper Cabinets; New settees and Salon Table - 1/2”
Hydroteck with Laminate both sides, Santos or African Mahogany
Trim ; Forward Cabin has 1/2” Armaflex closed cell foam behind new
Beveled Santos Mahogany on hull sides of cabin ; Beveled Santos
Mahogany on Forward Salon Bulkhead , aft of Nav station , Forward
bulkheads in Aft Cabin ( with new access door with 1’ closed cell
foam ) : Battery Bank area has beed reframed with Alaskan Yellow
Cedar framing and painted Beveled Alaskan Yellow Cedar front with
1/8’ spacing and new sliding doors; New Engine room Doors; Fiddles,
Trim and Base has been replaced in many areas of boat. Cost on this
is hard to estimate because it has been done over a couple years , but
guessing materials about $ 5,000.00- $6,000.00
10. 2018 Engine was lifted , Shaft was Aligned , new engine mounts ,
injectors pulled and rebuilt cost about ( materials and labor on this
was about $1,800.00 )
11. New 316 Stainless Steel New Found Metals Ports 2019 , cost
( Material and Labor as I had these installed , about $ 8,900.00 )
12 New 2019 Lewmar Ocean Series Hatches , with composite board
base plates made and glassed to cabin top for hatches to mount
onto , hatches were bedded using Butyl Tape to new base plates. Cost
about $3,000.00
13. Boat was re- rigged so all lines can be controlled from the cockpit
including reefing. New rope clutches , deck organizers , turning
blocks . About $ 1,800.00 - $ 2,000.00
14. 2019 Cap Rail was replaced using European First Quality Teak
( highest quality Teak that has such a high Silica content that my
lumber yard would not plane or put a straight edge on this rough
sawn wood ) . Cap rail was bedded using Butyl tape that outlasts any
Marine Sealant. Cost of materials $2,500.00- $2,800.00
15. Rocna 88 pound Anchor with custom stainless anchor roller .
Anchor $1,500.00 plus custom Stainless roller $750.00
16. Dickinson grill ( new burner and fittings included ) cost $270.00
17. 2019 Two new fiberglass hatches in cockpit; New fiberglass
“Turtle Back” over companionway ; New fiberglass helm seat cost
about $500.00
18. ***** Christmas 2018 boat was hauled out at Kohler Kraft boat yard
on Shelter Island . ***** Boat was on the hard for seven weeks as the
following work was done. ***** Yard bill for hauling out the boat, yard
time and relaunching for this time was about $ 7,000.00 *****
***** Work done at yard during this time *****
Bellow Waterline
Bottom paint was sanded off to Gell Coat; Hull was inspected and all
blisters were cut out and washed multiple times then allowed to dry
for four weeks, coated with West System Epoxy , filled with Fairing
Compound , Faired to surrounding hull. Below Water Line - Two Coats
of Epoxy Barrier Coat ; Two Coats of Epoxy Tie Coat; One Coat of Red
Ablative Bottom Paint; Three coats Black Ablative Bottom Paint , then
a Fourth coat three feet down from water line. This is a 5 year bottom
paint job ! None of the bottom paint coats was thinned , like normally
done at yards !!! Three thru hulls replaced. Cost of just materials
about $3,500.00
Water Line to Cap Rail
Hull was sanded ; all dings and imperfections filled and faired ; Two
coats of Alexseal High Build Primer; Two coats of Alexseal Finish
primer ; Two Coats Alexseal “Whisper Grey “; Boot Strip was
repainted with Alexseal Black . Cost of materials only ( this includes
the cost of The Alexseal paint used on Deck and Cabin top that was
applied at the Marina ) $3,500.00- $3,700.00
19. *****Painting done at Marina*****
Deck and cabin Top was sanded ; Filled and Faired as needed ; Two
Coats of Alexseal High Build Primer ; Two coats of Alexseal “Snow
White”; New Non Skid
