1995 35′ Shuttleworth Open 35

Dimensions
LOA: 35 ft 0 in
Beam: 23 ft 4 in
Minimum Draft: 1 ft 4 in
Maximum Draft: 6 ft 6 in

Accommodations
Number of double berths: 3
Number of heads: 2


Equipment and Specifications

DESIGN:

-John Shuttleworth designed catamaran

-Rounded bilges

-Dagger board in each hull

-Flush decks and open cockpit

-Companionways with hatches steps down to cabin areas in each hull

CONSTRUCTION
-All foam core/epoxy/vacuum bagged construction

-Hulls are a composite of 20 oz. uni-E-glass, 5/8 thick, 8 lb. Divinicell
foam; 24 oz. uni-B-glass, all epoxy resin and vacuum bagged

-Bulkheads are 1/2" Divinicell foam with 15 oz. uni-"E" glass and epoxy
resin; 4" tabbings

-Decking is E-glass/epoxy; foam core; vacuum bagged; Awlgrip LP paint and
non-skid

-Composite chain-plates, carbon rudders/post, dagger-boards, main beams

-Each hull has (6) watertight compartments in the bilges

-The rudders, rudder posts, dagger boards, tillers are all foam with carbon cloth and
epoxy resin

-Rudder is FG/foam epoxy twin-balanced spade kick-up and steering in
tiller across cockpit connected with tiller bar

-Finished in Awlgrip

 

ACCOMMODATIONS:

-3 double berths (2 port, 1 starboard)

-Foam cushions

-Two-burner alcohol stove

-(2) Marine head in each hull plumbed directly into integral holding tanks

-Vanity area in port hull

-Epoxy/foam cabinets and countertops

-LP interior paint

DECK EQUIPMENT:

-#55 Rocna, New 2013

-#35 Bruce

-#25 Bruce

-RODE: 250’ x 3/4” nylon

-CHAIN: 100’ x 5/16”

-Anchor windlass mounted on deck to port of mast & directly above chain

-(2) 12” SS bow cleats; (3) 10” SS stern cleats; (2) 8” SS midship deck
cleats

-deck hatches

 

RIGGING:

-45’ alum. w/ double spreaders nmast

-Cutter rigged w/ stay sail; running back stays

-All 1 x 19 SS standing rigging

-Head stay and cap shrouds are 3/8” Dyform

-Double braid running rigging

- Winches (3) Lewmar 40 AST; (3) Lewmar 16 AST; (3) Lewmar 8A

-(4) winch handles

-(8) Lewmar 7/16” line clutches

-boom vang/preventer;

-Dock lines

-Fenders

-Aluminum boat hook

-Cockpit cushions.

- Main sail boom cover

- 2 sun awnings

SAILS:

-340sq. ft. main

-400 sq. ft. Genoa

-390 sq. ft. Genny

-400 sq. ft. drifter

-280 sq. ft. lapper

-190 ft. sq. ft. Yankee

-135 sq. ft. stay sail

-40 sq. ft. storm stay sail

-1200 sq. ft. spinnaker

ENGINE:

-2008 Yamaha 9.9 high thrust outboard

-Engine is mounted on a HD sled faring which is retractable

-20 gallon fuel capacity in four tanks located under aft cockpit seat

NAVIGATION EQUIPMENT/ELECTRONICS:

-Panasonic VHF radiotelephone – 25 watt

-Garmin GPS 152

-Wind, Depth, and Log (Not fully functioning)

-Autohelm ST-4000 mounted on tiller

-(2) liquid, lighted 6" Ritchie BN-202 Compasses

- U.S.C.G. approved navigation lights on hull

-LED Masthead tri color (2014)

-12V 4000 candlepower hand held searchlight

ELECTRICAL SYSTEM:

-Plastic-coated copper strand wire, tinned loomed and secured wire

-12V DC breaker panel

-120V AC w/ shore power and breaker panel

-Vapor proof 3-pole master switch

-(2) Trojan T105 batteries (2014)

-(1)Everlast battery (2014)

-Acid-proof secured battery boxes

-Freedom inverter/charger- 1000 watt

-4 Solar Panels - 2 mounted on each hull Thin film Technology

-30 amp shorepower cord

-(3) integral water tanks located just aft of mast 2 25-gal. tanks plumbed to galley in starboard hull; one 30-gal. tank plumbed to the vanity in the port hull

-Manual foot pump in galley for fresh water

-Manual hand pump in port hull vanity (needs TLC or replacement)

-(2) fixed 10-gpm bilge pump (in each hull)

-(1) portable 20-gpm bilge pump

- (1) GRP seacock salt water inlet in head area in each hull

-(1) GRP seacock saltwater inlet in galley area

ADDITIONAL EQUIPMENT:

-(4) portable fire extinguishers (2014)

-(3) type IV life cushions

-20” MOB ring

-Lifesling

-Olin distress signal kit

-Tools, many spare parts

- Jordan series drogue

- (2) survival suits